4-Output AC Motor Controller

Category: Tag:

Additional information


The motor control power module is an interface that provides seamless integration of HomeWorks® QS systems with AC blinds, shades, louvers, projection screens, or any compatible AC motor. It provides four (4) independently controllable AC raise/lower outputs from one common AC input feed.

In HomeWorks® QS systems, the motor control power module’s high-voltage outputs for motor loads are fully programmable through the HomeWorks® system software.

Input Power
• Input voltage: 230 V~ 50/60 Hz
• 6 A maximum total input current
• At standby (no motors being driven), power is less than 1 W
• Lightning strike protection meets ANSI/IEEE standard 62.31-1980. Can withstand voltage surges of up to 6 000 V~ and current surges of up to 3 000 A

Output Capacity
• 1,5 A maximum motor load per channel (not for lighting control)
• Each zone supports only one motor; do not wire motors in parallel
• Raise and Lower outputs are mechanically interlocked to prevent simultaneously activating Raise/Lower outputs
• Designed to withstand 100 000 open/close cycles

Regulatory Requirements
• IEC/EN 60669-2-1, EN50428
• Lutron Quality Systems registered to ISO 9001.2008
• CE

Other Power Specifications
• Standby power: – 230 V~: 660 mW
• BTU/hour when fully loaded: 5 Environment
• Ambient temperature operating range (inside mounting panel): 0 ºC to 40 ºC (32 ºF to 104 ºF)
• Calibration point maximum: 65 ºC (149 ºF)
• Surrounding air temperature: Ta ≤ 65 ºC
• Relative humidity: less than 90% non-condensing
• For indoor use only

• Mains Wiring: 1,0 to 4,0 mm2 (18 to 12 AWG)
• Zone Wiring: 1,0 to 4,0 mm2 (18 to 12 AWG)
• QS Link Wiring: See Wiring: QS Link Mounting
• Use an IP20 (minimum) rated consumer panel or breaker panel with integrated DIN rail
• Width = 9 DIN modules (161,7 mm/6,4 in)